BESSEMER PROCESS

the first method discovered for mass-producing steel. Though named after Sir Henry Bessemer of England, the process evolved from the contributions of many investigators before it could be used on a broad commercial basis. It was apparently conceived independently and almost concurrently by Bessemer and by William Kelly of the United States. As early as 1847, Kelly, a businessman-scientist of Pittsburgh, Pa., began experiments aimed at developing a revolutionary means of removing impurities from pig iron by an air blast; Kelly theorized that not only would the air, injected into the molten iron, supply oxygen to react with the impurities, converting them into oxides separable as slag, but that the heat evolved in these reactions would increase the temperature of the mass, keeping it from solidifying during the operation. After several failures, he succeeded in proving his theory and rapidly producing steel ingots. In 1856 Bessemer, working independently in Sheffield, developed and patented the same process. Whereas Kelly had been unable to perfect the process owing to a lack of financial resources, Bessemer was able to develop it into a commercial success. Another Englishman, Robert Forester Mushet, found that adding an alloy of carbon, manganese, and iron after the air-blowing was complete restored the carbon content of the steel while neutralizing the effect of remaining impurities, notably sulfur. A Swedish ironmaster, Goran Goransson, redesigned the Bessemer furnace, or converter, making it reliable in performance. The end result was a means of mass-producing steel. The resultant volume of low-cost steel in Britain and the United States soon revolutionized building construction and provided steel to replace iron in railroad rails and many other uses. The Bessemer converter is a cylindrical steel pot approximately 6 m (20 feet) high, originally lined with a siliceous refractory. Air is blown in through openings (tuyeres) near the bottom, creating oxides of silicon and manganese, which become part of the slag, and of carbon, which are carried out in the stream of air. Within a few minutes an ingot of steel can be produced, ready for the forge or rolling mill. The original Bessemer converter was not effective in removing the phosphorus present in sizable amounts in most British and European iron ore. The invention in England, by Sidney Gilchrist Thomas, of what is now called the Thomas-Gilchrist converter, which was lined with a basic material such as burned limestone rather than an (acid) siliceous material, overcame this problem. Another drawback to Bessemer steel, its retention of a small percentage of nitrogen from the air blow, was not corrected until the 1950s. The open-hearth process, which was developed in the 1860s, did not suffer from this difficulty, and it eventually outstripped the Bessemer process to become the dominant steelmaking process until the mid-20th century. The open-hearth process was in turn replaced by the basic oxygen process, which is actually an extension and refinement of the Bessemer process.