STRAIN

in physical sciences and engineering, number that describes relative deformation or change in shape and size of elastic, plastic, and fluid materials under applied forces. The deformation, expressed by strain, arises throughout the material as the particles (molecules, atoms, ions) of which the material is composed are slightly displaced from their normal position. Strains may be divided into normal strains and shear strains on the basis of the forces that cause the deformation. A normal strain is caused by forces perpendicular to planes or cross-sectional areas of the material, such as in a volume that is under pressure on all sides or in a rod that is pulled or compressed lengthwise. A shear strain is caused by forces that are parallel to, and lie in, planes or cross-sectional areas, such as in a short metal tube that is twisted about its longitudinal axis. In deformation of volumes under pressure, the normal strain, expressed mathematically, is equal to the change in volume divided by the original volume. In the case of elongation, or lengthwise compression, the normal strain is equal to the change in length divided by the original length. In each case the quotient of the two quantities of the same dimension is itself a pure number without dimensions. In some applications, the change (decrease) in volume or in length for compression is taken to be negative, whereas the change (increase) for dilation or tension is designated as positive. Compressive strains, by this convention, are negative, and tensile strains are positive. (Top) Volume under compression, (centre) section of wire under tension, (bottom) metal tube under In shear strain, right angles (90 angles) within the material become changed in size, as squares are deformed into diamond shapes the angles of which depart from 90. Thus, in the illustration of the metal tube, the right angle CAF in the unstrained tube decreases to the acute angle BAF when the tube is twisted. The change in the right angle is, therefore, equal to angle BAC the tangent of which, by definition, is the ratio of BC divided by AC. This ratio is the shear strain, the value of which is zero for no deformation and becomes increasingly greater as angle BAC increases. Shear strains are also dimensionless.